Customization: | Available |
---|---|
Usage: | Workstation, Server |
Type: | Wired |
Suppliers with verified business licenses
Audited by an independent third-party inspection agency
Parameter | Symbol | Min | Typ | Max | Unit |
Storage Ambient Temperature | Tstg | -40 | +85 | ºC | °C |
Relative Humidity -Storage | RHS | 0 | 95 | % | % |
Relative Humidity -Operating | RHO | 0 | 85 | % | |
Module Supply Voltage | VCC | -0.5 | 3.6 | V |
Parameter | Symbol | Min. | Max. | Unit | |
Case Operating Temperature | Tcase | 0 | +25 | +70 | ºC |
Module Supply Voltage | VCC | 3.135 | 3.3 | 3.465 | V |
Signaling SpeedPer electricalchannel(4x25G NRZ) | S | - | 25.78 | - | Gb/s |
Power Consumption | P | - | - | 4 | W |
Parameter | Symbol | Test Point | Min | Typ | Max | Units | Notes |
AverageLaunchPower ,eachlane | POUT | TP2 | -6.2 | - | 4 | dBm | Average OpticalOutput |
Optical modulationAmplitude , each lane | OMA | TP2 | -4.2 | - | 3 | dBm | |
ExtinctionRatio | ER | TP2 | 3 | - | - | dB | |
Launch power in OMAouterminus TDECQ, each lane | OMA TDECQ | TP2 | -5.9 | - | - | dB | |
Optical OutputwithTxOFF | POFF | TP2 | - | - | -30 | dBm | |
Center Wavelength1 | λ | TP2 | 844 | 850 | 863 | nm | |
Center Wavelength 2 | λ | TP2 | 900 | 908 | 918 | nm | |
RMS Spectral Width1 | Δλ | TP2 | - | - | 0.6 | nm | |
RMS Spectral Width2 | Δλ | TP2 | - | - | 0.65 | nm | |
Optical return losstolerance | ORL | TP2 | - | - | 12 | dB | |
Transmitter and dispersioneye closure forPAM4 (TDECQ), eachlane | TDECQ | TP2 | 4.9 | dB |
Parameter | Symbol | Test Point | Min | Typ | Max | Units | Notes |
Average power at receiveinput, eachlane | PIN | TP3 | -7.9 | - | 4 | dBm | Note1 |
Receive power, each lane (OMAouter) | PIN(OMA) | TP3 | -5.9 | - | 3 | dBm | |
Unstressed receiver sensitivity(OMAouter),each lane | Sen | TP3 | - | - | max (-6.6,SECQ-8) | dBm | Note2 |
Center Wavelength1 | λ | TP3 | 844 | 850 | 863 | nm | |
Center Wavelength2 | λ | TP3 | 900 | 908 | 918 | nm | |
Receiver Reflectance | RFL | TP3 | - | - | -12 | dB | |
Rx_LOS of Signal- Assert | PA | TP3 | -30 | - | - | dBm | |
Rx_LOS of Signal-Deassert | PD | TP3 | - | - | -5.9 | dBm | |
Rx_LOS of Signal-Hysteresis | PHy | TP3 | 0.5 | - | - | dB |
I2CMemory Map(Based on SFF8636 2.10a) LowerPage | ||||||
Address | Name | Bits Value | Byte Value | Read-Only /Read/Write | Support | |
Byte | Bit | |||||
0 | 7-0 | Identifier | 11h | Read- Only | Yes | |
1 | 7-0 | Revision Compliance | 08h | Read- Only | Yes | |
2 | 7-4 | Reserved | status | |||
3 | Reserved | |||||
2 | Flat_mem | 0b | Read- Only | Yes | ||
1 | IntL | Read- Only | Yes | |||
0 | Data_Not_Ready | Read- Only | Yes | |||
3 | 7 | L-Tx4LOS | status | status | Read- Only | Yes |
6 | L-Tx3LOS | status | Read- Only | Yes | ||
5 | L-Tx2LOS | status | Read- Only | Yes | ||
4 | L-Tx1LOS | status | Read- Only | Yes | ||
3 | L-Rx4LOS | status | Read- Only | Yes | ||
2 | L-Rx3LOS | status | Read- Only | Yes | ||
1 | L-Rx2LOS | status | Read- Only | Yes | ||
0 | L-Rx1LOS | status | Read- Only | Yes | ||
4 | 7 | L-Tx4 AdaptEQ Fault | status | status | Read- Only | Yes |
6 | L-Tx3 AdaptEQ Fault | status | Read- Only | Yes |